Skip to Content
Apollo Servicing & Support Center

Apollo Servicing & Support Center

Apollo Pro IOT Module Replacement

Tools Required:
5mm Allen key
Philips head screwdriver

Parts Required:
Apollo Pro IOT Module Assembly

If you require parts due to a manufacturing defect while under warranty, please request parts here.

Incorrect assembly, repair, and/or maintenance of your Apollo scooter can cause performance or component failure of your scooter, loss of control, property damage, serious injury or even death. If you are not sure you have the experience, skills, and tools to correctly repair your Apollo scooter, DO NOT ATTEMPT THE REPAIR and consult our support team or your local, qualified scooter technician. Any produce failure, defect, and/or damages resulting from unauthorized repairs, maintenance, and/or modification will not by covered by our Limited Warranty and are performed at your own cost and risk.

1

How to Replace the IOT Module on Your Apollo Pro 2023

2

Step 1: Remove Deck Cover:

  1. Start by peeling off the grip tape from the deck and set it aside.

  2. Use the 5mm Allen key to remove the six screws holding the deck cover in place.

  3. Gently lift the deck cover, being cautious of connected wires. If it's stuck, tap the back of the footrest with a rubber mallet to aid removal.

3

Step 2: Remove IoT Module:

  1. Flip the deck cover over and disconnect the connectors attached to it.

  2. Use a Philips head screwdriver to remove the three screws securing the IoT module. Carefully push down on the module to assist in its removal. Run the wires through the designated hole.

4

Step 3: Install New IoT Module:

  1. Place the new IoT module in position and secure it with the three screws. Avoid overtightening to prevent damage to the plastic.

  2. Reconnect the orange to orange connectors, providing power to the side LEDs. Plug in the green to green connector for the IoT module.

  3. Before securing the deck cover, ensure no wires are pinched or crushed. Lay the cover flat and check for proper wire placement.

5

4. Re-install Deck Cover:

  1. Carefully place the deck cover back on the scooter. Double-check that none of the wires are obstructed or crushed by screws.

  2. Secure the deck cover with the six screws using the 5mm Allen key.

  3. Align and reapply the grip tape to the deck.

Besoin d'aide ?

Poser une autre questionApollo Servicing & Support Center
Sélectionner un autre produit
© 2024|Sitemap